SD Connect C4 Configuration Failure Solved by Firmware Reflash
Page 1 of 1
SD Connect C4 Configuration Failure Solved by Firmware Reflash
obd2tool Wed Dec 04, 2019 9:10 pm
If you failed to set up or configure Star diagnosis SD Connect C4, showing 00 error on main unit, you can follow firmware reflash steps below to solve the problem.
sdc4-name-00-solution-00
Error on main unit.
Unscrew and disassemble sd c4 unit
This is correct wiring diagram.
Right click on the icon “StartKeyCenter”, then “Properties” – “Find target”
On the desktop, right click on “StartKeyCenter”, then option “Properties” – “Find target” – C:\programmer \SDconnect Toolkit file, find out last 3 folder: update_automatic, update_manual;update_special. , correct names by deleting the final letter”x”
At the right corner of the desktop, click “Administrator”.
This toolkit is being initialized
Click “00/Cable Accessible”
Click on “Register / Configure”
Update “CSD_2_11.zip”
The system software was successfully updated.
Back to update “Bootimage_2_3.zip”
The system software was successfully updated.
Back to click on “00/ Cable Accessible”
You see it’s accessible.
Click on “Software update”, then “03 PMpic29_cpld13.zip”
The system software was successfully updated.
Check the information
Back to the desktop, right click on “StartKeyCenter”, then option “Properties” – “Find target” – C:\programmer \SDconnect Toolkit file, rename the last 3 folder, add a suffix “x“, the final folder name will be update_automaticx, update_manualx; update_specialx.
Done.
sdc4-name-00-solution-00
Error on main unit.
Unscrew and disassemble sd c4 unit
This is correct wiring diagram.
Right click on the icon “StartKeyCenter”, then “Properties” – “Find target”
On the desktop, right click on “StartKeyCenter”, then option “Properties” – “Find target” – C:\programmer \SDconnect Toolkit file, find out last 3 folder: update_automatic, update_manual;update_special. , correct names by deleting the final letter”x”
At the right corner of the desktop, click “Administrator”.
This toolkit is being initialized
Click “00/Cable Accessible”
Click on “Register / Configure”
Update “CSD_2_11.zip”
The system software was successfully updated.
Back to update “Bootimage_2_3.zip”
The system software was successfully updated.
Back to click on “00/ Cable Accessible”
You see it’s accessible.
Click on “Software update”, then “03 PMpic29_cpld13.zip”
The system software was successfully updated.
Check the information
Back to the desktop, right click on “StartKeyCenter”, then option “Properties” – “Find target” – C:\programmer \SDconnect Toolkit file, rename the last 3 folder, add a suffix “x“, the final folder name will be update_automaticx, update_manualx; update_specialx.
Done.
obd2tool- Posts : 168
Join date : 2012-05-03
Similar topics» How to Renew Lonsdor K518ISE Firmware Program
» Resolving the Frustrating Issue of John Deere Diagnostics Kit Connection Failure
» Lonsdor K518ISE update error solution renew firmware
» How do you Connect OBD-II to some Subaru Outback?
» How to reset MB SD connect c4 LAN & WLAN IP address
» Resolving the Frustrating Issue of John Deere Diagnostics Kit Connection Failure
» Lonsdor K518ISE update error solution renew firmware
» How do you Connect OBD-II to some Subaru Outback?
» How to reset MB SD connect c4 LAN & WLAN IP address
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum|
|
|