Running the ISTA Program on BMW ICOM NEXT

To effectively run the ISTA program on BMW ICOM NEXT, follow these steps:

1. Prepare the Equipment
- Make sure your laptop is working properly and has Windows (preferably Windows 10 for better compatibility).
- Install the latest version of ISTA+ and ISTA/P software on your laptop.

2. Connecting ICOM NEXT
- Connect your ICOM NEXT device to your laptop using an Ethernet cable.
- Make sure ICOM NEXT is on and connected to the vehicle via the OBD-II port.

3. Setting up network configuration
- Go to the network settings on your laptop.
- Set your Ethernet adapter (connected to ICOM NEXT) to a static IP address:
- IP Address: 169.254.92.38
- Subnet Mask: 255.255.255.0
- Disable any VPN or additional network connections to avoid potential conflicts.

4. Starting the ISTA Software
- Open ISTA+ or ISTA/P on your laptop.
- The software should automatically detect the ICOM NEXT connection.

5. Vehicle Selection
- Select the vehicle you are working on via the ISTA interface.
- Ensure the ignition is "ON" but do not start the engine.

6. Perform Diagnostics or Programming
- Navigate to the desired function, such as diagnostics, programming, or module updates.
- Follow the on-screen instructions to complete the task, if necessary.

7. Monitor the Process
- Monitor the process for any error messages or warnings.
- If you experience any problems, check your connections and settings to make sure everything is working properly.

8. DONE AND DISCONNECT
- Once your diagnostic or programming task is complete, exit the software properly.
- Disconnect ICOM NEXT from the vehicle and laptop.

9. Saving Data
-Remember to save any logs and reports generated during the process for later use.

By following these steps you will be able to effectively run the ISTA program using BMW ICOM NEXT for diagnostic and programming tasks.